|
I run KixTart 3.63, NT4 workstations.
Works allright on 250 NT4 workstations - but on 2 workstations I get an error when calling an EXE file from a script:
SHELL 'CMD.EXE /C "\\COR001AV\ofcscan\AUTOPCC.EXE"'
Here is the error:
The instruction at "...." referenced memory at "....". The required data was not placed into memory because of an I/O error status of "....".
If I remove the call I get no error.
If I run the exe file from a command prompt I get no error.
The crazy about it is that it runs OK from all other workstations except these 2 ....
Any ideas are very welcome
Knud
| 
